ATE setup and command summary for 2414 and 2475:

1.	CPU 2000 loaded with 2414 code Revision 0.9 with Common CPU  Build#: 10 (Mar 26 2001).



2.	2414 Personality Bd. Rev. E reworked to a Rev. F per DWO10954.
	SFTWRJMPR7 and SFTWRJMPR5 installed.
	LED ID jumper installed at J3 pin 2 to pin 3.

3.	CPU power up messages:

	
	CPU2000 Boot Loader
	Version: 1.00 (RC5) Build#: 1 (Aug 11 2000)

	***ETC Test: ALL OK ***
	CPU flash size: 1048576 (0x100000) Bytes
	CONSOLE:>

	2414 RI Detector
	Version: 0.9 - with Common CPU Build#: 10(Mar 26 2001)

	***NVRAM descriptor initialized - shutting down***

	2414 RI Detector
	Version: 0.9 - with Common CPU Build#: 10(Mar 26 2001)

	Non-volitile RAM corrupted. Factory Defaults Set

	Init Bypass Jumper detected - hardware modules not initialized
	System Init complete

	CONSOLE:>

4.	Commands used, ATE to Console Port:


	1. acq -i <cr>		Used to initialize Front End Boards and to null system offset
				expected response: CONSOLE:>

	2. xread .1 xx <cr>	Used to acquire raw data from the A\D converters. Number of points varies.
				expected response:
				secs	DiodeA	DiodeB	A+B
				0.0	 data	 data	sum
				0.1	 data	 data	sum 
				0.2	 data	 data	sum
						.
						.
						.

						
	3. <cr>			Used to check if console port is availible.
				expected response: CONSOLE:>